RECERTIFICATION IPC 7711/7721 CERTIFIED IPC TRAINER (CIT) - ETECH Training

info@etech.training

call: + 31 (0)45 711 23 90

Privacy Policy and Cookie Policy

info@etech.training

call: + 31 (0)45 711 23 90

Privacy Policy and Cookie Policy

Module 1 - IPC-7711 / 7721C Introduction and Common Procedures

This Module contains general content which pertains to all other section of the IPC-7711/7721C. This module must be successfully completed before certification to any additional knowledge modules may be granted.

4
Module 2 Workmanship - Wire Splicing

This knowledge module contains the basic skills required for the workmanship of Wire Splicing

8
Module 3 Workmanship - Conformal Coating

This knowledge module contains the basic skills required for the workmanship of Conformal Coating

9
Module 4 Workmanship - Through Hole Components

This knowledge module contains the basic skills required for the workmanship of Through Hole Components

6
Module 5 Workmanship - Chip and MELF Components

This knowledge module contains the basic skills required for the workmanship of Chip and MELF Components

7
Module 6 Workmanship - Gull Wing Lead Components

This knowledge module contains the basic skills required for the workmanship of Gull Wing Lead Components

17
Module 7 Workmanship - J-Lead Components

This knowledge module contains the basic skills required for the workmanship of J-Lead Components

11
Module 9 Workmanship - Laminate Repair

This knowledge module contains the basic skills required for the workmanship of Laminate Repair

4
Module 10 Workmanship - Circuit Repair

This knowledge module contains the basic skills required for the workmanship of Circuit Repair

6
Instructor Skills

This knowledge module contains the Skills for teaching the lesson plan effectively.

1
- Skills for teaching the lesson plan effectively

RECERTIFICATION IPC 7711/7721 CERTIFIED IPC TRAINER (CIT)

This content is protected, please and enroll course to view this content!

Prev Procedure 4.1.3, Surface Solder Removal – Braid Method

Next Procedure 5.3.2, Chip Installation – Point to Point

Leave A Reply Cancel reply

You must be logged in to post a comment.

ETECH training is the leading training center for IPC training in Europe.

Be the first to hear about our latest courses by signing up to our mailing list.

IPC Training

Other Training

ESD

PCB fabrication

Manufacturing & Production

Our services

Training services

Consulting services

Manufacturing & Production

All other services

Address

info@etech.training

Kloosterweg 1

NL-6412 CN Heerlen

Netherlands

CC: 75322129
VAT: NL860237801B01

IBAN: NL17RABO0116731974
BIC: RABONL2U

Connect

© 2020 ETECH training

Privacy Policy and Cookie Policy

Web Development by Noury Dautzenberg

X